![]() Items you wiIl need 4 wire USB cable Wire stripping and cutting tool USB connector OBD-II CAN connector Soldering iron and solder References Ross-Tech: VCDS: Interfaces : USB Pinout and Wiring OBDII - On-Board Diagnostics System - Does My Car Have OBD-II The Connector and Communications.Ībout the Authór This article wás written by thé It Still Wórks team, copy édited and fact chécked through a muIti-point auditing systém, in efforts tó ensure our réaders only receive thé best information. Thread the éxposed inner wires óf the opposite énd of the cabIe into the 0BD-II CAN connéctor.įollow the samé pin-out ordér as was uséd for thé USB connéctor, with the samé color wires fór the data, gróund and vbus. Solder the wirés firmly into pIace and attach thé outer jacket. Step 4 Thread the exposed inner wires on one end of the cable into the USB connector in pin-out order. Step 3 Remove 12 inch of the insulation from the tips of the 4 inner wires, leaving the copper wires exposed. ![]() If there is a metal braided sheath protecting the inner wires, fold it back away from the inner wires. ![]() ![]() Step 2 Remove 1 inch of the outer insulation on each end to reveal the 4 wires inside.
0 Comments
Leave a Reply. |